Installing zimbra on an external firewire drive (OSX): Difference between revisions
(Adding categories) |
(Adding article footer) |
||
Line 13: | Line 13: | ||
service --list | grep com.zimbra.zcs If nothing is returned you can add it manual with | service --list | grep com.zimbra.zcs If nothing is returned you can add it manual with | ||
launchctl load /opt/zimbra/conf/com.zimbra.zcs.plist | launchctl load /opt/zimbra/conf/com.zimbra.zcs.plist | ||
{{Article Footer|unknown|5/1/2007}} | |||
[[Category:Installation]] | [[Category:Installation]] | ||
[[Category:OSX]] | [[Category:OSX]] |
Revision as of 20:35, 11 February 2010
Firewire drives are not considered local devices by default, therefor setuid/setgid perms are ignored.
1)Plug the firewire hard drive, formated it with hfs and created an entry for it in /etc/fstab like this one
UUID=5A0CBF6E-5EE8-3E14-A24A-36144214A36C /opt/zimbra hfs rw,local,auto 1 2
- check this link on how to get the UUID of the device. "http://forums.macrumors.com/archive/index.php/t-170786.html"
2)You may need to change the config of automount with the following command defaults write /Library/Preferences/SystemConfiguration/ autodiskmount AutomountDisksWithoutUserLogin -bool true
3)The installer should have registered the service with launchd. You can verify this with service --list | grep com.zimbra.zcs If nothing is returned you can add it manual with launchctl load /opt/zimbra/conf/com.zimbra.zcs.plist