Difference between revisions of "CLI zmrestore restoreToTime Network Edition only"

m (New page: More on zmrestore can be found at CLI_zmrestore_Network_Edition_only --restoreToTime replays redo log sequences until time specified When using this command please use the -lb argu...)
 
m (category tag)
Line 43: Line 43:
  
 
In this case a new account is created named restored_user@domain.com (you could then grab out the material you want, imapsync, or choose to run the command without the new target/test account).
 
In this case a new account is created named restored_user@domain.com (you could then grab out the material you want, imapsync, or choose to run the command without the new target/test account).
 +
 +
[[Category:Command Line Interface]]

Revision as of 02:07, 17 January 2008

More on zmrestore can be found at CLI_zmrestore_Network_Edition_only


--restoreToTime replays redo log sequences until time specified


When using this command please use the -lb argument to specify a full backup that took place prior to the time you wish to restore to.

zmbackup -a user@domain.com --restoreToTime <arg> -lb full-200xxxxxx

You can specify an exact time, the incremental backup label, or the redo log sequence to restore to. Restore stops at the earliest possible point in time if more than one point in time restore options are specified.


Two common ways to write the <arg> are:

YYYY/MM/DD hh:mm:ss

YYYYMMDD.hhmmss


Specify date/time in one of these formats:

2006/08/02 16:55:05 268

2006/08/02 16:55:05

20060802.165505.268

20060802.165505

20060802165505268

20060802165505


Note: After performing the following point-in-time restore, you should run a complete backup for those accounts to avoid future restore problems with those accounts.

---

Tip: A good way to test what your restore is going to look like is to restore to a new target account where a prefix is prepended to the original account names:

zmbackup -a user@domain.com --restoreToTime <arg> -lb full-200xxxxxx -ca -pre restored_

In this case a new account is created named restored_user@domain.com (you could then grab out the material you want, imapsync, or choose to run the command without the new target/test account).

Jump to: navigation, search